13
PC/Mac setup
To input or output your PC/Mac’s audio to/from the unit, install the dedicated audio driver
software and/or Setting Utility on your computer.
If you install the dedicated software to your PC (Windows), the Setting Utility and audio driver
software will be installed.
If you use a Mac, only the Setting Utility will be installed.
• For information on the latest system requirements, compatibility, and supported operating
systems, visit the URL below.
alphatheta.com/support/
• Operation isn’t guaranteed on all PC/Mac models, even if the system requirements are
met.
• Operation isn’t guaranteed when multiple units are connected to a PC/Mac.
• If a PC (Windows) without the dedicated audio driver software installed is connected to the
unit, errors may occur on the PC.
• Malfunctions may occur due to incompatibility with other software installed on a PC/Mac.
Installation
Notes on installation
• Turn the unit off and disconnect the USB cable connected to the unit and the PC/Mac
before installation.
• Close all applications running on the PC/Mac before installation.
• You’ll need admin rights to install the dedicated software on your PC/Mac.
• Read the Software License Agreement terms carefully before installation.
• If you quit the installation halfway through, perform the installation procedure again from
the beginning.
• After the installation is complete, connect the PC/Mac to the unit.
• Operation isn’t guaranteed on all PC/Mac models.
To Next Page
Loading...