58
Additional information
Connections
[No dedicated audio driver and/or Setting Utility installed.] is
displayed when the unit is connected to a PC/Mac.
• Install the dedicated software on the PC/Mac. If the software is already installed, reinstall it.
Sound from a connected PC/Mac isn’t outputting from the
unit.
• Make sure the PC/Mac is connected properly.
• We recommend you connect this unit and a PC/Mac directly with a USB cable.
• When using a USB hub, use a product recommended by the manufacturer of your PC/Mac.
• We don’t guarantee the operation of all USB hubs.
• Select this unit in the audio output device settings in the computer’s software. For details,
refer to the instruction manual for the software.
• Set the input selector switch to [ ].
Sound is distorted when a turntable is connected to the
[PHONO] terminals on the unit or the status of the channel
level indicator doesn’t change when turning the [TRIM] knob.
• Check if the connected turntable has a built-in phono equalizer (if it does, connect the
turntable to the [LINE] terminals).
• If the turntable has a PHONO/LINE selector switch, set it to PHONO.
• If the audio interface for PC/Mac, which is connected between the unit and the turntable, is
a line-level device, connect the interface to the [
LINE] terminals.
To Next Page
Loading...