Why does my Alutech Gate Opener stop while moving?
If your Alutech Gate Opener drive stops while the gate is moving, and a reversal is possible, it could be due to an incorrect force setting or an obstacle hindering the gate's movement. Try adjusting the drive force and removing any obstructions that may be in the way.
What to do if Alutech Gate Opener drive is not working but indicator is on?
If your Alutech Gate Opener is not working, but the control unit indicator is on, the issue could be a faulty electrical connection or the drive might be released. Check all connections and ensure that inputs on the device with normally closed contacts are closed. Also, make sure the drive is engaged.
Why is my Alutech Gate Opener moving in the wrong direction?
If your Alutech Gate Opener gate moves in the wrong direction, it is likely due to improper electrical connections. Check the electrical connections of the drive.
What to do if Alutech Gate Opener doesn't respond to photocells?
If the Alutech Gate Opener drive does not respond to obstacles on the optical axis of the photocells, it indicates incorrect operation of photocells. You should check whether the photocells are working correctly and replace them if needed.
Why did my Alutech Gate Opener gate leaf stop suddenly?
If a gate leaf of your Alutech Gate Opener stops moving suddenly, it's possible that the drive motor thermal protection has activated. Allow the drive to cool down.
Overview of the AM-5000KIT kit for automating swinging gates.
Lists components included in the CUSD-1 control unit kit.
Diagrams and data for determining drive fitting locations for gate opening inwards.
Step-by-step procedure for mounting the drive onto the gate leaf and post fittings.
Procedure for releasing the drive for manual gate operation using a special key.
Instructions for setting mechanical stops for gate opening and closing limits.
Steps for fitting a guard bar to the drive groove to ensure proper operation.
Identification and function of components on the control unit module board.
Wiring details and connector assignments for the control unit.
Steps to verify the correct functioning of the drive and safety devices.
Final steps before putting the automation system into service.
General| Motor Voltage | 24V DC |
|---|---|
| Operating Temperature | -4°F to +122°F |
| Protection Class | IP44 |
| Motor Type | DC |
| Control Type | Remote control |
To Next Page