5000KIT | 5000KIT AUTOMATION SET 73
MOUNTING
ø8
Figure 11. Mounting a front tting
1
2
3
Figure 12. Mounting the drive on a rear tting
!
Figure 13. Mounting the drive
on a front tting
Figure 14. After the drive is mounted,
the connector must not contact the enclosure
4.3 MANUAL RELEASE
To release the drive (g. 15), use the special key supplied with the drive kit. Turn the key to ~ 180 º
towards the OPEN label. To return the drive to the locked (engaged) state, turn the key towards
the CLOSE label. Once you have locked it, move the leaf manually, slowly, without shocks or
impacts until you hear a distinctive engagement click.
Table 3
To Next Page
Loading...