5000KIT | 5000KIT AUTOMATION SET70
MOUNTING
>0°
>0°
!
Figure 6. Required drive position
relative to a leaf
Figure 7. Drive-through width
for a gate opening outwards
4.2 DRIVE MOUNTING
For a gate opening inwards, perform the mounting works with the gate closed. For a gate opening
outwards, perform the mounting works with the gate opened.
Recommended mounting sequence:
• after defining the mounting dimensions, A and B and a location to attach a rear fitting to
the post, select an assembly type for the rear fitting (tab. 6, fig. 8). When needed, cut the
bracket of the rear fitting to the required size. In case the bracket is not long enough, use
improvised materials to add length to the rear fitting.
• fix the rear fitting on the post, either bolting it down or welding (fig. 9). Make sure the
fitting is positioned horizontally. The fitting should be assembled and mounted rigidly.
• ensuring compliance with the mounting dimension W, fix the front fitting on the leaf
(fig. 11). The length of the front bracket can be adjusted (fig. 8), in this case note the
condition > X. In case the bracket is not long enough, use improvised materials to add
length to the front fitting. The fitting can be bolted or welded to the leaf (fig. 9). Use a spirit
level to verify throughout the mounting process.
• mount the drive on the rear (fig. 12) and front (fig. 13) fittings. Prior to mounting the drive
on the front fitting, lubricate the fitting surface of its connector with grease. To mount the
drive on the front fitting, release the drive (section '4.3. Manual release') and move the leaf
manually.
• mechanical opening and closing stops should be installed according to section
'4.4.SettingUp Final Positions'. Attention! Stops should not be installed beyond the teeth
on the enclosure.
• with the drive released, make sure that the leaf is moving smoothly when opened or
closed, and the drive does not hit the post or the gate leaf. Check the opening angle of
the leaf. There should be no friction between the slide nut of the drive and the enclosure
(fig. 14).
• check the drive installation and weld the parts of the front and rear fittings (fig. 10), making
sure to protect the drive from the welding effects. Protect the welded spots from corrosion
by applying a protective coating.
To Next Page
Loading...