5000KIT | 5000KIT AUTOMATION SET86
OPERATION
8.2 COMMISSIONING
A drive system can be commissioned only after the testing has been successfully completed.
Partial commissioning or temporary operation are forbidden.
For commissioning, proceed as below:
• prepare and keep technical documentation for the drive system. The documentation shall
include a general drawing, a wiring diagram, a maintenance schedule, as well as an assembly
and operation manual, completed as appropriate.
• Fasten a permanent safety sticker next to the gate, containing the instruction with the
following meaning: ‘Attention! Automatic drive. Keep away from the gate(s) to avoid any
harm due to their unexpected activation. Do not let children near the gate.’
• Fasten a permanent sticker or a sign next to the gate, detailing the release and manual
opening instructions.
• Hand over the completed (filled in) ‘Assembly and operation manual’ to the user (owner).
• Prepare the ‘Maintenance schedule’ and give it to the user (owner). Instruct them about
maintenance rules.
• Instruct the owner about the existing hazards and risks and inform about safe operation rules.
Explain to the owner the need to warn the persons operating the gate about the existing
hazards and risks, safe operation rules.
9. OPERATION
In the course of operation:
• the product shall not be used by children or persons with limited physical, sensory, or mental
abilities, as well as by persons with insufficient experience and knowledge.
• Do not let children play with control elements. Remote controls shall be stored in areas
unreachable by children.
• Keep remote controls away from heating sources and never leave them under direct sunlight
or in wet locations.
• Do not touch a moving gate or its moving parts.
• Before setting the gate in motion, make sure no people, animals, vehicles, or objects are in the
gate impact (operation) area. Monitor the gate motion. No people or vehicles shall be allowed
through the gate, while it is moving.
• Regularly check the drive system. In particular, check cables, supports, gate posts, and the
mounting hardware for any signs of wear, damage, or imbalance. It is prohibited to use a gate
requiring repair or adjustment because a mounting defect may result in an injury or product
failure.
• Regularly check the operation of safety devices.
• Check the gate and the drive operation areas for presence of any foreign objects and build-ups
due to unfavourable weather conditions (vegetation, branches, snow, ice, etc.) that can impair
the drive operation.
Perform scheduled maintenance of the drive system to ensure its ecient and safe operation.
Scheduled maintenance shall strictly comply with the existing regulatory documents, instruc-
tions in this manual, instructions for other involved devices, and safety rules. Perform scheduled
maintenance, at least, once every six months.
Scheduled maintenance shall include the following actions:
• check the wear of the components supplied in the kit and that of the gate components (feed
nut assembly, coupling, brackets, axes, cabling, hinges, brackets, other gate parts, etc.), paying
To Next Page
Loading...
Need help?
General