5000KIT | 5000KIT AUTOMATION SET66
PREPARATION FOR ASSEMBLY
Use multicore cable with double insulation for electrical connections of the drive system com-
ponents. The parameters of the electrical cables used (cross section, number of wires, length,
etc.) should comply with the connection diagram, device power, laying distance, way of laying,
ambient conditions.
Do not establish any electrical connections while laying electrical cables. Make sure that the
cables are isolated and therefore they are not live.
The electrical cable of the control and safety devices should be laid separately from the cables
with mains voltage. The cables should be protected from contact with any rough and sharp
surfaces, use corrugated tubes, pipes, and cable ducts to lay the cables.
The instructions in the manual are for reference only since the mounting locations for the drive
and the drive system components may dier. The installation personnel responsible for mounting
the drive system components must look for the most suitable solution.
Prior to mounting:
• determine the location to mount each component of the drive system (fig. 3). Both the
drive and the control unit must be mounted on the interior surface of the gate. Together
with the user, determine the locations for mounting control devices.
• Determine a diagram for connecting electrical devices of the drive system.
• Make sure all the required tools and materials are available.
• When needed, prepare the posts and walls to suit the mounting dimensions of the drive
(e.g., provide recesses in the concrete, brickwork, etc.). The mounting locations for the drive
must be solid and, if needed, reinforced (e.g., with metal plates, angles, etc.).
• Lead the electrical cables to the locations where the drive system components are to be
mounted, observing the regulations in force. In accordance with the typical diagram (fig. 3),
it is recommended to use cables with a length not exceeding 20 m.
• Remove unnecessary parts (cables, angles, etc.) and disconnect all the ancillary equipment.
To Next Page
Loading...
Need help?
General