65
ERROR CODE DESCRIPTION, POSSIBLE CAUSE AND SOLUTION
E-13
(CARD NOT
REMOVED
PROPERLY)
The card was removed too soon, et al. Reinsert the time card and WAIT for the
MX-300 to eject it before removing it from the card slot.
E-14
(5-SECOND
RULE ERROR)
The same time card was inserted within five seconds of being punched. Wait five
seconds until reinserting the same time card.
E-15
(4-PUNCH RULE)
The time card has already been punched four times this day.
E-16
(OVERPRINT
PREVENTION)
Someone tried to clock in with a time card that was already clocked in for the day by
pressing the IN button again. The MX-300 will not print over of an already punched
time. Try another button. The same applies for clocking in and out for personal errands
and clocking out for the day.
E-17
(CLOCK
TAMPERING
ERROR)
Someone tried to tamper with the clock (set it back, et al) and then clock in, out, et
al. Readjust the clock to the correct time.
E-18
(CALCULATION
MODE
INCORRECT)
This error occurs when you attempt to change the time card's hourly worker shift
type (fixed Ö open OR open Ö fixed) in the middle the month. Try another time
card instead.
E-19
(TOO LATE TO
CLOCK OUT FOR
PREVIOUS DAY'S
ALL-NIGHT)
This error occurs when you attempt to clock out for an all-night that began the
previous day after the same time card has been clocked in for today.
The MX-300 can only punch the OUT time for an all-night at the time it ends.
E-20
(ALREADY
REGISTERED)
Someone tried to register an already registered card.
E-21
(NO CARD DATA)
There is no data for time card currently inserted.
E-22
(50-ITEM
REGISTRATION
RULE)
The number of items registered has exceeded the 50 item limit.
E-23
(DUPLICATE
CARD NUMBER)
Due to a change in the Pay Period Ending Date setting, the same card number was
generated twice. Use a new time card.
To Next Page
Loading...
