16.8 F45063: Setpoint value cannot be maintained
The desired spread rate cannot be spread with the working width and speed.
1. Reduce speed.
2. Reduce spread rate.
3. Reduce the working width.
16.9 F45069: Recurring error when determining the calibration factor
During the automatic calibration, the newly calculated calibration factor was below 0.5
twice.
1. Remove the blockage on the shutter.
2. Calibrate fertiliser manually.
3. Recalibrate the scale.
4. Set "Rice" special spreading material.
CMS-T-00009027-A.1
CMS-T-00009002-A.1
MG7387-EN-II | B.1 | 12.01.2022
48
To Next Page
Loading...
