Ametek AMEVision - Sensor (Analyzer) Name Configuration

PN 9000-165-VE, Rev P
Sensor (Analyzer) Name Conguration
The default name of the analyzer is WDG-n, where ‘n’ is the address of
the analyzer. If you have multiple sensors, entering a name for each
sensor you want to connect is recommended but not required.
1. From the Main Menu screen, press ENTER/MENU to access the Congu-
ration Menu.
2. Press the Left or Right arrows to locate the System Name Conguration
menu and press ENTER/MENU.
3. Use the keypad to enter the name(s) of your analyzer(s). Enter the name as
you would on a mobile phone. The keypad displays the characters as you
enter them. For example, to select the letter ‘E’ press the ‘3’ key twice. To enter
the number ‘2’ press the ‘2’ key four times (e.g., ‘A-B-C-2.’)
Maximum number of characters is 10.
4. Navigate to ACCEPT and press ENTER/MENU after each name to accept
the name of that sensor.
Figure 2-4.
Sensor (Analyzer) Name
Conguration screen.
2-6 | Thermox
®
AMEVision Display User Interface