Ametek AMEVision - Calibration; Types of Calibration; Manual Calibration Procedure; Automatic Calibration Setup

PN 9000-165-VE, Rev P
Personnel and Equipment Safety Information
This section describes important safety information to avoid personal injury and dam-
age to the equipment while installing, operating, maintaining, or servicing the equip-
ment. All safety regulations, standards, and procedures at the analyzer location must
be followed.
All personnel involved with the installation, start-up, operation, maintenance, service, or
troubleshooting of the analyzer must review and follow these Warnings and Cautions.
Do Not Operate without Covers
To avoid electric shock or re hazard, do not operate this product with covers or
panels removed.
Use Caution When Lifting
Use caution when lifting the product from its crate.
Do Not Operate in Explosive Atmosphere
To avoid injury or re hazard, do not operate this product in an explosive
atmosphere unless you have purchased options that are specically designed for
these environments.
Use Proper Wiring
To avoid re hazards, use only the wiring specied in the “Installation and
Start-Up” chapter of this manual.
Avoid Electrical Overload
To avoid electrical shock or re hazard, do not apply a voltage to a terminal that
is outside the range specied for that terminal.
Ground the Product
Follow the grounding instructions provided in the “Installation and Start-Up”
chapter of this manual. Before making connections to the input or output termi-
nals of this product, ensure that the product is properly grounded.
Use Proper Fuse
To avoid re hazard, use only the fuse type and rating specied for this product.
Contents | vii