Controller/Interface | 2-9
PN 9000-165-VE, Rev P
Sensor Conguration
Select Sensor Options
Figure 2-7.1.
Select Sensor Options screen.
1. From the Main Menu screen, press ENTER/MENU to access the Congu-
ration Menu.
2. Press the Left or Right arrows to locate the Sensor Conguration menu
and press ENTER/MENU.
3. Options for the various sensor combinations are listed. Select the options
you are using: Combustibles or Methane or both.
If you have a ow sensor on your analyzer, make sure that Flow is
selected on this screen.
Figure 2-7.2.
Select Sensor Options screen.
Flow Sensor selection.
Auto Calibration is not a standard feature of the WDG-V Analyzer. Do
not select Auto Calibration unless your analyzer is equipped with a
Remote Calibration Unit (RCU).
To Next Page
Loading...