PN 9000-165-VE, Rev P
Utility
Utility Menu
1. From the Main Menu screen, press ENTER/MENU to access the menus.
2. Press the Left or Right arrows to locate the Utility menu and press ENTER/
MENU.
There are ve utility menus, each described in the following pages:
Detect Sensor Utility
The Detect Sensor screen lists the currently connected sensors, and provides
the ability to scan the network in search of sensors.
1. Press the Left or Right arrows to locate the Detect Sensor menu and press
ENTER/MENU.
2. Press ENTER/MENU to access the Detect Sensor screen.
3. The sensors that are connected are automatically displayed on the Detect
Sensor screen. When more than one sensor is connected to the analyzer, a
GREEN indicator designates the enabled sensor and RED indicators desig-
nate disabled sensors.
If a sensor is connected but not displayed on the screen, navigate
to the SEARCH button and press ENTER/MENU to search for the sen-
sor.
Figure 3-7.
Detect Sensor Utility screen.
4. Use the navigation arrows to toggle sensors On/O.
5. Press CANCEL to exit the screen.
Alarms and Warnings | 3-11
To Next Page
Loading...