Ametek AMEVision - Firmware Upgrade Utility; Parameter Management Utility

PN 9000-165-VE, Rev P
Parameter Management Utility
This menu is used to save or restore sensor user parameters or revert the sen-
sor parameters to factory default.
1. Press the Left or Right arrows to locate the Parameter Management
menu.
2. Press ENTER/MENU to access the Sensor Parameters Management
menu. The Sensor Parameter Management screen displays.
3. Use the navigation arrows to select the function:
- SAVE sensor’s current parameters
- RESTORE previously user-saved sensor parameters or
- REVERT to the factory default parameters.
4. Press ENTER/MENU to save the parameters.
5. Press CANCEL to exit the screen.
Firmware Upgrade Utility
This menu displays the currently installed versions of the Sensor and Host
rmware. Use this menu to:
• Verify the installed Sensor Firmware version or download upgraded or
new rmware
• Verify the installed Host Firmware version or download upgraded or new
rmware
Firmware upgrades are carried out using a USB ash drive. It is neces-
sary to plug the USB ash drive into the USB port inside the AMEVision
enclosure to download the software.
1. Press the Left or Right arrows to locate the Firmware Upgrade menu and
press ENTER/MENU.
2. Press ENTER/MENU to access the Firmware Upgrade screen.
3. Use the navigation arrows to select the option to upgrade and press EN
TER/MENU.
3-12 | Thermox
®
AMEVision Display User Interface