Ametek BROOKFIELD DVNext

M19-2101 REVISION 2.0 DVNEXT RHEOMETER - OPERATIONAL MANUAL
Table 5-1: Factory Default User Settings (continued on following page)
Administrator Power User User
General
Settings
Enforce Spindle MUST be scanned in
External Mode Only
Use Accessory Rules • • •
Set Default Temperature Set Point N/A N/A N/A
Temperature Probe Oset • •
Allow Test Done Alarm • • •
QC Alarm • • •
Global Alarm • • •
Pop-Up Warnings • • •
Dismiss Pop-Up Warnings • •
Customize Spindle List • •
Speed List • •
Regional Settings • • •
Measurement Units • • •
Language • • •