M19-2101 REVISION 2.0 DVNEXT RHEOMETER - OPERATIONAL MANUAL
1.7 Cleaning
Make sure that the instrument is in a clean, dry working environment (dust free, moderate temperature,
low humidity, etc.).
Make sure the instrument is on a level surface.
Hands/fingers must be clean and free of sample residue. Not doing so may result in deposit build up on
the upper part of the shaft and cause interference between the shaft and the pivot cup.
Be sure to remove the spindle from the instrument prior to cleaning. Note left-handed thread. Severe
instrument damage may result if the spindle is cleaned in place.
When cleaning, do not apply excessive force, which may result in bending spindles.
Instrument and Display:
Immersed Components (spindles):
Clean with a dry, non-abrasive cloth. Do not use solvents
or cleaners. The instrument housing is manufactured from
polycarbonate ABS. Clean Instrument housing with mild soap
and water. Do not apply solvent to the instrument!
Spindles are made of stainless steel. Clean with a
non-abrasive cloth and solvent appropriate for sample material.
To Next Page
Loading...
Need help?
General
