Dansensor® LeakPointer 3/3
+
EN User Guide 29
P/N 380064-F
06/2021
Get started
When you start the device for the first time and before you start making measurements, it is
recommended that you perform some basic device settings.
NOTE! To be able to change device settings you must change the device to
“Administrator” access level.
To do so select “Access” from the “Main Menu” - see "Access" on page 65 for details.
Device Settings
Go through the parameters available in the Settings menu and make appropriate
settings - see "Settings" on page 79 for details.
Set up Users
From the factory no default users have been created, but we highly recommend that you
create specific users, so that you can separate measurements performed by different users
later on for use in statistics etc. - see
"Access" on page 65 and "Login" on page 84 for details.
Set up Products and Workflows
From the factory no default products have been created, but we highly recommend that
you create specific products, so that you can separate the different measurements later on
for use in product statistics etc. - see
"Product setup" on page 30, "Products" on page 56 for
details.
To Next Page
Need help?
General
