54 User Guide EN Dansensor® LeakPointer 3/3
+
P/N 380064-F
06/2021
Cleaning
General
Performing cleaning and maintenance regularly reduces the chances of equipment failure.
CAUTION! Personnel performing any maintenance or cleaning must familiarize
themselves with the information in "Safety and handling instructions" on page 93
before attempting any of these procedures.
CAUTION! Never use mineral oil, steam or boiling water on or near the chamber.
See "Consumable parts and options" on page 91 for details about consumables and
replacement parts.
Cleaning
Use the ON/OFF button on the back of the device to switch the device off.
For normal cleaning use a soft, lint-free cloth with a mild soap solution. Avoid getting
moisture in openings.
Use alcohol to remove any chamber sealing residue from the base plate .
The fan in the top of the chamber should be cleaned as often as necessary depending on
the environment, but we recommend to clean it at least once every month.
Use e.g. an air pressure gun to gently blow air through the fan.
CAUTION! Blowing the air gun directly at the fan can cause it to run very fast. This
can potentially damage the fan.
NOTE! When using compressed air for cleaning, make sure that air is dry and oil
free.
To Next Page
Loading...
Need help?
General
