Dansensor® LeakPointer 3/3
+
EN User Guide 15
P/N 380064-F
06/2021
2. Setting up
Moving/lifting
CAUTION! When lifting or moving the device, this should be done by 2 persons
grabbing the device underneath the bottom in each side.
CAUTION! Never tilt the LeakPointer 3
+
device more than 45 degrees in any
direction relative to the horizontal, as this may cause the oil in the vacuum pump to
enter the pump’s vacuum chamber, which can cause serious damage to the pump
impeller.
CAUTION! The vacuum pump in LeakPointer 3
+
exhausts through a hole in the
bottom plate. This hole must NOT be blocked.
NOTE! Place the device on a stable and even surface and ensure that the height of
the surface allows for convenient operation as well as easy loading and removal of
test samples.
To Next Page
Loading...
