Dansensor® LeakPointer 3/3
+
EN User Guide 19
P/N 380064-F
06/2021
3. Operating
Basics
CAUTION! If the device is operated in a cold and high humidity environment it is
advisable to let it heat up for 5-10 minutes after it has been switched on.
Switching on/off
1. Use the ON/OFF button on the back of the device to switch the device on and off.
2. When the device is switched on, the splash screen is displayed for a few seconds while
device is initializing.
The screen shows the currently installed firmware version .
3. When the device is ready and if no login is required, the display will show:
Current user is the default Operator.
4. If, however, login is required the Access menu appears.
To Next Page
Loading...
Need help?
General
