Dansensor® LeakPointer 3/3
+
EN User Guide 93
P/N 380064-F
06/2021
Appendix
Safety and handling instructions
WARNING! Personnel operating and maintaining the device must be familiar with
all aspects of its operation and be proficient in maintenance.
Such personnel should review the following precautions to promote safety
awareness.
Failure to follow the safety instructions could result in fire, electric shock, injury, or
damage to Dansensor® LeakPointer 3 or other property.
NOTE! The manufacturer cannot be held responsible for any damage caused by
incorrect operation or maintenance of the device.
Handling and maintenance
Be sure to disconnect electrical power and unplug the unit before performing any cleaning
or maintenance.
When operating or maintaining the equipment always obey the relevant rules and
regulations for workers safety.
Handle the device with care. It is made of metal, glass, and plastic and has sensitive
electronic components inside.
The device can be damaged if dropped, burned, or crushed, or if it comes in contact with
liquid.
Do not use a damaged device, such as one with a cracked screen, as it may cause injury.
Do not cover the device with a cloth or piece of plastic to protect it from dust, as this
prevents free air circulation around the device and might lead to overheating.
Do not expose the device to heavy moisture or heat and keep it away from direct sunlight.
Repairing
Don’t open the device and do not attempt to repair it yourself, as this may damage it or
may cause injury to you.
If device is damaged, malfunctions, or comes in contact with liquid, contact your
authorized MOCON Dansensor A/S service provider.
Cables
If using other third-party cables and power plugs, make sure that they are compatible with
USB 2.0 or later, and that the power supply and plugs are compliant with applicable
country regulations.
Replace damaged cables immediately. Using damaged cables can cause fire, electric shock,
injury, or damage to the device or other property.
To Next Page
Loading...
Need help?
General
