12 User Guide EN Dansensor® LeakPointer 3/3
+
P/N 380064-F
06/2021
Accessories
The following accessories are included:
Power supply cable
For connecting the device to a power outlet - the appropriate connector for the wall
outlet is not included in the delivery.
Septa (100 pcs.)
When performing pressure measurements in a package for product setup purposes, a
septum should be applied to the package in order to ensure a leak free gas extraction
and to protect the package from tearing at the piercing point - see
"Product setup" on
page 30 for details.
PackBase mesh (models with PackFix only)
Use the mesh together with the legs to adjust the PackBase for a specific package
type - see
"Adjusting the height of the PackBase" on page 38 for details.
PackBase legs (4 sets) (models with PackFix only)
Use the legs together with the mesh to adjust the PackBase for a specific package
type - see
"Adjusting the height of the PackBase" on page 38 for details.
Needles (10 pcs.)
For measure hose
Leak Simulation Kit
For gain adjustment measurements - see "Determination of the Leak Correction Factor" on
page 34 for details.
Measure hose, Delta P
For performing pressure measurements in a package - see "Product setup" on page 30 for
details.
To Next Page
Loading...
Need help?
General
