Ametek Thermox TM2000 - Page 64

4-6 | Thermox TM2000 Oxygen Analyzer
 Select the operational mode of the sensor - either normal or hydrocar-
bon upset condition (Sensor Configuration).
 Define Series 2000 communication parameters (Communication).
 If initiating an automatic calibration or verification using a digital
input, define whether the input should trigger a calibration or a verify
(Remote Switch Config).
Figure 4-3.
Overview of Setup Key
functions
SETUP KEY
Menu Options
Functions/Options
Display
Select info for Display Line 1.
Select info for Display Line 2.
Select info for Display Line 3.
Passwords Create a system password
Process Pressure
Select a positive or negative process pressure.
Enter process pressure value.
System Tests Perform internal diagnostics on Series 2000.
System Serial #
View serial number for Series 2000.
View manufacturing number for Series 2000.
Primary Calibration
Perform an automatic, remote, or manual primary cali-
bration.
Sensor Conguration Select sensor type.
Communications Dene communications parameters.
Remote Sensor Conguration
Dene wheather digital input should start an automatic
calibration or an automatic verify.