5.1 Load ing and trans por ta tion
•
To lift the ma chi ne, hook the cra ne hook (1) into the cen tral
point sus pen si on (2).
45020000-2 HbmG gnu thci dreV nna mmA 9102/90
5. Trans port
68
De ath ha zard from sus pen ded load!
Crush ing haz ard from fall ing or tilt ing of the ma chine.
w
It is for bid den to
w walk un der sus pended loads,
w stand un der sus pended loads,
w ride on sus pended loads.
w
En sure that no per sons will be en dan gered.
w
Only use suf fi ciently strong and se cure load ing
ramps when load ing.
w
Check the con tact points (frame, lift ing rings) be -
fore use for dam age and wear. Im me di ately re place
dam aged parts.
w
Se cure the ma chine against roll ing or slip ping off
and against tip ping over.
w
When load ing, lash ing down and lift ing the ma chine
al ways use the pro vided lift ing points.
w
Af ter loa ding, lock or re mo ve the draw bar.
To Next Page
Loading...
