8.4 Exciter
8.4.1 Oil chan ge / Oil le vel
•
Uns crew ven ting screw (3), oil fil ling plug/dip stick (1) and oil
drain plug (2).
•
Drain-off old oil.
•
Screw-in oil drain screw (2).
•
Fill-in new oil through the oil fill hole (1). See lu bri ca ti on plan
for quan ti ty and qua li ty.
•
Re place oil fill ing plug/dip stick (1) and ven ting screw (3).
•
Uns crew oil fil ling plug/dip stick (1), check the oil le vel again
and top up with oil if ne ces sa ry.
•
Re pla ce oil fil ling plug/dip stick (1).
45020000-2 HbmG gnu thci dreV nna mmA 9102/90
8. Main ten an ce (Ma chi ne)
82
Bur ning ha zard.
Work ing on the ex citer may cause a burn ing haz ard
from hot oil.
w
Wear safety equip ment (gloves).
w
Slowly, ca re ful ly open the oil drai na ge screw to re -
lea se pres su re.
En vi ron men tal ha zard through ope ra ting ma ter -
ials!
w
Col lect dis charg ing oil and dis pose of in an en vi ron -
men tally friendly man ner.
w
Do no al low it to en ter the ground wa ter, wa ter bo -
dies, or se wa ge sys tem.
w
Check / chan ge ex ci ter oil when its warm.
w
When the dip stick is scre wed in, the op ti mal oil le vel
is bet ween the «MIN» and «MAX» mar kings.
To Next Page
Loading...
