AMX DAS-M-0404 - Page 80

RS-232 Commands / Messages
70
Mi Series Audio Controllers
RS-232 Controller Command Messages (Cont.)
MSSTs,x Set Source State, where:
• ‘s’ is the desired source, (1-8)
•‘x’ is the desired state, valid values are:
2: Pause
1: On
0: Off
Source State Status
- or -
ERR
MCMDs,x Send Source Command, where:
•‘s’ is the desired source, (1-8)
•‘x’ is the desired command index, valid values depend on the
source type.
•‘y’ is the play option for the Sirius internal tuner only. Other
source types will ignore. (1=play, 0=browse).
ACK
- or -
Sirius Channel Number
(Sirius Type Only)
- or -
ERR
MSBLr,x Set Room Balance, where:
•‘r’ is the desired room, (1-64)
•‘x’ is the balance value, valid values are:
0: balanced evenly
1...10: Full Left...10% Left
11...20: 10% Right... Full Right
Balance Status
- or -
ERR
MGBLr Get Room Balance, where:
‘r’ is the desired room, (1-64)
Balance Status
- or -
ERR
MSPRr,x Set Room Privacy, where:
•‘r’ is the desired room, (1-64)
•‘x’ is the desired privacy state, valid values are:
0: Off
1: On
Privacy Status
- or -
ERR
MGPRr Get Room Privacy, where:
‘r’ is the desired room, (1-64)
Privacy Status
- or -
ERR
MSRGs,b8,b7,
b6,b5,b4,b3,
b2,b1
Create Room Grouping, where:
• ‘s’ is the source which to associate the rooms, (1-8)
• ‘b8’.... ‘b1’ is a binary room selection bitmap where all rooms to
be grouped have a binary 1 in the room position. The most
significant bit in ‘b8’ is for room 64 and the least significant bit in
‘b1’ is for room 1.
Notes:
A room grouping will be considered invalid if there are not at least
two rooms selected for the group.
Only one room group can be associated with any given source.
Example:
MSRG,1,0,0,0,0,0,0,0,37
Groups zones 1, 3, and 6 to source 1.
Note: The number 37 is calculated by applying a binary mask on
the bits to be grouped.
• Zone 1 represents the Least Significant Bit and zone 8, the MSB.
• The binary bitmask for 1,3, and 6 is 0010 0101 which is 37 in
decimal.
Room Grouping Status
- or -
ERR