Upgrading Modero Firmware
113
VG Series Modero Touch Panels
5. Follow the procedures outlined within the Step 2: Upgrade the NXA-BASE/B firmware via an IP section on
page 111.
FIG. 99 RGB Adjustment page (showing the default values)
Incoming signal shown in the background
Firmware version of the NXA-RGB card
Firmware version of the NXA-AVB/RGB
If firmware is updated to either the panel or the breakout box, both units must be
power-cycled for the panel to detect and display the new BOB firmware version.
To Next Page
Loading...
