Firmware Pages and Descriptions
123
VG Series Modero Touch Panels
Video - RGB Settings Page
The RGB Settings page (FIG. 109) sets the RGB properties for the detected NXA-RGB card located within the target
panel on Slot 2 where pass-thru occurs.
The elements of the RGB Settings page are described in the table below:
Video Settings Page Elements (Cont.)
Format: Allows you to press this blue field and cycle through a choice of available video formats (NTSC,
PAL, SECAM, or Auto detect).
• Default = Auto.
Brightness: Use the UP/DN buttons to alter the brightness level of the incoming signal.
• Range = 0 - 255, default = 128.
Contrast: Use the UP/DN buttons to alter the contrast level of the incoming signal.
• Range = 0 - 255, default = 128.
Saturation: Use the UP/DN buttons to alter the color saturation level of the incoming signal.
• Range = 0 - 255, default = 128.
Hue: Use the UP/DN buttons to alter the hue level of the incoming signal.
• Range = 0 - 255, default = 128.
FIG. 109
RGB Adjustment page (showing the default values)
RGB Settings Page Elements
Back: Saves the changes and returns you to the previously active touch panel page.
Connection Status icon: This visual display of the connection status allows the user to have a current visual update of
the panel’s connection status regardless of what page is currently active.
• A Lock only appears on the icon if the panel has established a connection with a currently
secured target Master (requiring a username and password).
Settings: • The Default Settings button sets the RGB settings to their default values (indicated in this
table).
• The Undo Changes button disregards any changes made on the page since the last
settings were saved.
• The Save Settings button saves any changes made to the RGB Adjustment page.
• The Sync on Green button sets the NXA-RGB card to search for the sync signal on
Green signal.
Version: Displays the firmware version being used by the internal NXA-RGB card.
BOB Version: Displays the firmware version of the communicating NXA-AVB/RGB Breakout Box.
• If firmware is updated to either the panel or the breakout box, both units must be power-
cycled for the panel to detect and display the BOB firmware version.
Status: Displays the input signal properties of the signal routed through the internal NXA-RGB card
(H-pixel x V-pixel @ Hz). An example is: 1024x768@85Hz.
Incoming signal shown in the background
Once you are done making your
adjustments, click SAVE SETTINGS.
Firmware version of the NXA-RGB card
Pressing this area activates the
Full Screen Edit mode
Firmware version of the NXA-AVB/RGB
To Next Page
Loading...
