Touch Panel Accessories
27
VG Series Modero Touch Panels
NXA-CFTP Compact Flash (FG2116-22)
Every Modero panel is shipped with two factory default modules: an EXM Memory Module and a Compact Flash card.
These panels are shipped with a 256 memory module which is not upgradeable. The default 128 MB Compact Flash
card is factory programmed with specific panel firmware and is the only upgradeable memory component. This
component can be ordered from AMX in several different upgrade sizes (as listed in the following table):
Upgrading the internal components involves opening the panel enclosure/outer housing to access the internal circuit
board, removing the existing part, and replacing them with the upgrade components, as described in the following
sections.
NXA-PCI80211G Wireless Card (FG2255-04)
The 1200V-Series and VG-Series Modero touch panels can connect to an internal NXA-PCI80211G mini-PCI Wireless
Card (FIG. 13) connected to two antennas (57-2250-10).
The NXA-PCI80211G card functions using a 2.4GHz bandwidth with a maximum data transfer rate of 54Mbps. This
card is compatible with IEEE 802.11 standards such as: 802.11b and 802.11g.
The NXA-80211G allows the end-user to take advantage of larger bandwidth to utilize features such as: streaming digital
video and audio, wireless intercom, Motion JPEG, networked video, and standard wireless Ethernet communication to
both a NetLinx controller and networked computers.
Please follow your particular Wireless Access Point’s instruction manual for the correct procedures to setup either a
secured or unsecured connection.
Optional Compact Flash Memory Upgrades
Compact Flash:
NXA-CFTP256M - 256 MB Compact Flash card (FG2116-23)
NXA-CFTP512M - 512 MB Compact Flash card (FG2116-24)
NXA-CFTP1G - 1 GB Compact Flash card (FG2116-25)
It is recommended that any upgrade of internal equipment be done simultaneously in
order to reduce the risk of damage to internal components.
FIG. 13 NXA-PCI80211G mini-PCI Wireless Card
To Next Page
Loading...
