Firmware Pages and Descriptions
147
VG Series Modero Touch Panels
Checking the Panel Statistics
1.
Press the Tools button in the Protected Setup Navigation Buttons section. This opens the Tools menu.
2. Within the Tools menu, press the Panel Statistics button. All connection statistics are contained on this page, e.g.,
Received, Processed, and Dropped ICSP Messages.
Refreshing the Panel Statistics
1.
Press the Tools button in the Protected Setup Navigation Buttons section. This opens the Tools menu.
2. Within the Tools menu, press the Panel Statistics button.
3. Push the Refresh button.
Clearing the Panel Statistics
1.
Press the Tools button in the Protected Setup Navigation Buttons section. This opens the Tools menu.
2. Within the Tools menu, press the Panel Statistics button.
3. Push the Clear button.
4. Confirm your selection.
Connection Utility
The options on the Connection Utility popup window (FIG. 128) allow you to utilize your panel as a site survey tool.
While in this page, move around your wireless network coverage area and see if there are any weak points within the
spaces between your WAPs.
Features on this page include:
FIG. 128 Connection Utility popup window
Connection Utility Popup Window Elements
Close: Closes the Connection Utility popup.
Connection Status icon: The icon in the upper-right corner of the utility provides a constant visual indication of
current connection status.
A message is sent to the master once per second and expects a response.
• If it is received the button stays green.
• If it is missed the button goes yellow.
• After three misses (3 seconds) it will go red until a response from the master is
received, and then it will be green again.
Once per second, a user can know whether they are standing in a good wireless area (all
green), an area of limited coverage (lots of yellow, some green, some red), or an area with
no coverage (all red).
Connection Information
Master IP The IP Address for the connected master.
Panel IP The IP Address for the panel.
To Next Page
Loading...
