AMX NXD-1200VG - Page 148

Firmware Pages and Descriptions
134
VG Series Modero Touch Panels
Protected Setup Page Elements (Cont.)
Options: Allows you to select various touch panel features:
• The Function Show button enables the display of the channel port and channel code
in the top left corner of the button, the level port and level code in the bottom left
corner, and the address port and address code in the bottom right corner (see
FIG. 116 for an example of the function locations).
• Use the Page Tracking button to toggle page tracking. When enabled, the touch
panel sends page data back to the NetLinx Master, or vice versa depending on the
touch panel settings.
• Use the Telnet button to enable or disable the telnet server on the panel. This feature
focuses on direct telnet communication to the panel.
• Use the Front Button Setup Access button to activate the grey Front Setup Access
button (located below the LCD) to access the firmware pages.
- Default condition is On.
- Press and hold this grey button for 3 seconds to access the Setup page.
- Press and hold this grey button for 6 seconds to access the Calibration
page.
• Use the Security button to toggle between three security settings: Standard Security,
Secure, and DoD. Refer to the Security Settings section on page 135 for very
important information on using this feature.
System Recovery: Allows you to either reset the touch panel to factory default settings and/or wipe out all
existing touch panel pages:
• The Reset System Settings button allows a user to wipe out all current configuration
parameters on the touch panel (such as IP Addresses, Device Number assignments,
Passwords, and other presets).
- Pressing this button launches a Confirmation dialog that asks you to confirm
your selection.
- This dialog is configured with a delay timer that does not enable the YES
button for 5 seconds. This delay provides an additional amount of time for
the user to confirm their decision.
• The Remove User Pages button allows you remove all current TPD4 touch panel
pages currently on the panel (including the pre-installed AMX Demo pages).
- Pressing this button launches a Confirmation dialog which asks you to
confirm your selection.
- This dialog is configured with a delay timer that does not enable the YES
button for 5 seconds. This delay provides an additional amount of time for
the user to confirm their decision.
FIG. 116
Button/slider Function Show example
Slider
Button
Channel Code
Number
3,132
2,8 3,50
Channel Port
Level Port
Address
Port
Address Code
Number
Channel Code
Number
7,10
Channel Port
4,9
1,8
Channel Code
Number
Level Port
Channel Code
Number
Address
Port
Address Code
Number