Installation Procedures: 12" and 15" Panels
56
VG Series Modero Touch Panels
6. Insert the main 12-inch Modero unit into an NXA-RK12 (FIG. 46) or the 15-inch Modero into an NXA-RK15
(FIG. 47).
7. Secure the panel to the NXA-RK frame by first inserting and then tightening the four #4-40 screws (provided). Line
up the four mounting holes and use a grounded Phillips-head screwdriver to tighten the screws in a clockwise
direction.
8. Insert the NXA-RK (with connected NXD unit) into the equipment rack, making sure to align the screw holes along
the sides on the NXA-RK with the holes in the equipment rack.
9. Use a grounded Phillips-head screwdriver to secure the NXA-RK (with connected NXD unit) to the equipment rack
using #10-32 screws (not included).
10. Place the magnet faceplate back onto the main NXD unit by gripping the faceplate and placing it on the housing
with gentle force. Make sure to align the Microphone, Light, and PIR Motion sensor locations to their respective
openings on the front bezel/faceplate.
11. Reconnect the terminal RJ-45, Ethernet, USB, and any optional audio/video wiring to their respective locations on
either the NXA-AVB/RGB Breakout Box, Ethernet port, or NetLinx Master.
FIG. 46 NXD 12 inch Wall Mount panel installed into an NXA-RK12 Rack Mount Kit
FIG. 47 NXD 15 inch Wall Mount panel installed into an NXA-RK15 Rack Mount Kit
Faceplate
Rack mount
frame (NXA-RK12)
Faceplate
Rack mount frame
(NXA-RK15)
To Next Page
Loading...
