Installation Procedures: 17" Panels
71
VG Series Modero Touch Panels
3. Remove any screws/nails from the surface, along the notched beam, before beginning the cutout process.
4. Follow the procedures outlined within Steps 1 - 5 on page 34 thru page 36 to carefully reinstall the LCD panel back
into the back box housing.
5. Cut out the surface for the Wall Mount using the dimensions shown in FIG. 60.
6. Remove the magnetic faceplate/bezel (A in FIG. 61) from the main NXD unit (B in FIG. 61) by gripping the
faceplate and pulling with gentle outward force.
In this sample installation, the left beam is notched and the back box rests against the
right beam.
FIG. 60 NXD-1700VG Wall Mount panel dimensions using #4 mounting screws
To Next Page
Loading...
