Medium-consistency pump MC
STANDARD, C-01-000000
Rev. 0, 2010.02.09 ERECTION WORK and TRANSPORT Kap.4 , Seite 1 of 12
GRZ-2698569-v1-Erection.FM
4 ERECTION WORK and TRANSPORT
4.1 General
This chapter describes certain steps for transport, storage and installation
of the medium-consistency pump which may be the responsibility of the
user.
Activities which are carried out by ANDRITZ AG, including works
assembly, are not the subject of this description.
4.2 Safety regulations
General safety
instructions
All applicable accident prevention rules must be observed.
Do not exceed permissible crane loads and weights on lifting gear and
ropes/shackles. Secure loads against falling down.
Do not step or walk below suspended loads. Standing below suspended
loads is dangerous and thus, strictly forbidden.
Jolts must be avoided. This refers especially to the handling of
pre-assembled machines.
Qualification of
personnel
assigned
Transport and unloading is to be carried out by personnel specially
familiar with such work.
Workers entrusted with lifting and conveying equipment must have the
required national qualification.
Start-up may only be carried out by trained, skilled workers.
Personal
protective apparel
The following protective equipment must be worn when carrying out field
installation and transport work:
• Hard hat
• Protective gloves
• Protective shoes
• Goggles
Tools Only use tools of a reputable brand and in good condition for any work
performed on the medium-consistency pump.
DANGER
Disregarding the safety regulations may cause a risk to life and limb.
If the safety regulations are disregarded, this may cause a risk to life
and limb and damage to the machine or its components.
All safety instructions in this section must be strictly observed.
To Next Page
Loading...
