A-4 Functional Listings
A-32 PN: 10370-10374 Rev. F MG369xC GPIB PM
Table A-19. Stored Setup GPIB Command List
Command Code Function Page
RCF Prepares the MG369xC to receive a new instrument setup recalled from
the controller.
3-97
RCM Prepares the MG369xC to receive a new instrument setup and new
stored setups recalled from the controller.
3-97
RSN(m) Recalls the instrument setup stored in internal setup memory location m. 3-99
SAF Outputs the current instrument setup to the controller. 3-100
SAM Outputs both the current instrument setup and all stored instrument
setups to the controller.
3-101
SM Recalls the next stored instrument setup in sequence. 3-111
SSN(m) Saves the current instrument setup to internal setup memory location m. 3-115
Table A-20. Sweep GPIB Command List (1 of 2)
Command Code Function Page
AD1 Selects F1-F alternate frequency sweep. 3-2
AD5 Selects F5-F alternate frequency sweep. 3-3
AD6 Selects F6-F alternate frequency sweep. 3-3
AF1 Selects F1-F2 alternate frequency sweep. 3-5
AF3 Selects F3-F4 alternate frequency sweep. 3-5
AFU Selects full range alternate frequency sweep. 3-5
AUT Selects automatic sweep triggering. 3-14
DF0 Selects F0-delta frequency sweep mode. 3-25
DF1 Selects F1-delta frequency sweep mode. 3-25
DF5 Selects F5-delta frequency sweep mode. 3-26
DF6 Selects F6-delta frequency sweep mode. 3-26
DU0 Deselects dual step sweep mode. 3-29
DU1 Selects dual step sweep mode. 3-30
EXT Selects single sweep triggering. 3-34
FUL Selects the full range sweep mode. 3-44
HWT Selects external sweep trigger. 3-47
LGS Selects logarithmic step sweep. 3-56
LIS Selects linear step sweep. 3-57
MAN Selects manual (step) frequency sweep. 3-65
MNT Selects manual trigger. 3-67
RSS Resets a sweep if in progress. 3-99
SF1 Selects the F1-F2 sweep mode. 3-104
SF3 Selects the F3-F4 sweep mode. 3-104
SP0 Deselects non-equally spaced step sweep. 3-112
SP1 Selects non-equally spaced step sweep. 3-113
To Next Page
Loading...
Need help?
General
