Anritsu Site Master - Saving a Setup; Recalling a Setup; Storing a Display

Step 20.
If the Limit needs to be turned OFF, press the LIMIT
soft key on the Scale Menu. If the Limit needs to be
turned ON, press the LIMIT soft key again. This will
open the Limit parameter for entry. If needed, enter
the desired numerical value using the keypad or the
Up/Down Arrow key (Figure 2-1, page 2-0). Press
ENTER when the data entry is complete.
Step 21. If you wish to have an audible beep when the trace is
above the limit line, press the OPT soft key from the
Main Menu (page 2-8).
Step 22.
Press the B2 soft key from the Option Menu (page
2-13) to toggle the limit beep indicator ON.
Saving a Setup
Step 23.
Press the SAVE SETUP key (Figure 2-1, page 2-0).
Step 24. Enter the desired numerical value (1 to 6) using the
Up/Down Arrow key. Press ENTER when data entry
is complete.
Recalling a Setup
Step 25.
Press the RECALL SETUP key.
Step 26. Enter the desired numerical value (1 to 6) using the
Up/Down Arrow key. Press ENTER when data entry
is complete. To restore the factory defaults, enter 0,
then press ENTER.
Storing a Display
Step 27.
Press the SAVE DISPLAY key and it will display
the next available memory location.
Step 28.
Press ENTER to store the display in the current
empty memory location or enter the desired numeri-
cal value using the keypad (1 to 70) or the Up/Down
Arrow key. Press ENTER when entry is complete.
2-34
Chapter 2 Operation