Anritsu Site Master - Recalling a Display; Coax;Waveguide Loss Measurement; Selecting a Frequency Range

Step 29.
Enter the current time in HHMM format. Press
ENTER when entry is complete.
Step 30.
Enter the current date in DDMMYY format. Press
ENTER when entry is complete.
Step 31.
Enter an 8-digit reference designator. Press ENTER
when entry is complete.
Recalling a Display
Step 32.
Press the RECALL DISPLAY key.
Step 33. Enter the desired numerical value using the keypad (1
to 70) or the Up/Down Arrow key. Press ENTER
when data entry is complete.
Coax/Waveguide Loss Measurement
Selecting a Frequency Range
Step 1.
Press the MODE soft key, from the Main Menu
(page 2-8).
Step 2. Select Coax/Waveguide Loss measurement using the
Up/Down Arrow key. Press ENTER when selection
is complete.
Step 3.
Press the FREQ soft key, from the Main Menu
(page 2-8).
Step 4.
Press the F1 soft key from the Frequency Menu (page
2-11).
Step 5. Enter the desired numerical value using the keypad or
the Up/Down Arrow key (Figure 2-1, page 2-0).
Press ENTER when data entry is complete.
Step 6.
Press the F2 soft key.
2-35
Chapter 2 Operation