Symbols
Table 2-1 provides a listing of the symbols used as condition indicators
on the LCD display.
Self Test
At turn-on, the Site Master runs through a series of quick checks to en-
sure the system is functioning properly. Note that the battery voltage
and temperature are displayed in the lower left corner below the self
test message. If the battery is low, or if the ambient temperature is not
within the specified operational range, Self Test will fail. If Self Test
fails AND the battery is fully charged AND the Site Master is within
the specified operating range, call your ANRITSU Service Center.
Error Codes
Self Test Errors
A listing of Self Test Error messages is given in Table 2-2.
Range Errors
A listing of Range Error messages is given in Table 2-3.
Replacing the Battery
Replacing the battery is the only recommended field-level maintenance
action. If your battery fails, contact your ANRITSU Sales Office or
Service Center. Table 2-4, on page 2-58, provides a listing of current
service centers.
2-52
Chapter 2 Operation
To Next Page
Loading...
