Anritsu Site Master - Saving a Setup; Recalling a Setup; Storing a Display

Step 16. If you wish to have an audible beep when the trace is
above the limit line, press the OPT soft key from the
Main Menu (page 2-8).
Step 17.
Press the B2 soft key from the Option Menu (page
2-13) to toggle the limit beep indicator ON.
Saving a Setup
Step 18.
Press the SAVE SETUP key (Figure 2-1, page 2-0).
Step 19. Enter the desired numerical value (1 to 6) using the
Up/Down Arrow key. Press ENTER when data entry
is complete.
Recalling a Setup
Step 20.
Press the RECALL SETUP key.
Step 21. Enter the desired numerical value (1 to 6) using the
Up/Down Arrow key. Press ENTER when data entry
is complete. To restore the factory defaults, enter 0,
then press ENTER.
Storing a Display
Step 22.
Press the SAVE DISPLAY key. This will display the
next available empty memory location.
Step 23.
Press ENTER to store the display in the current
empty memory location or enter the desired numeri-
cal value using the keypad (1 to 70) or the Up/Down
Arrow key. Press ENTER when entry is complete.
Step 24.
Enter the current time in HHMM format. Press
ENTER when entry is complete.
Step 25.
Enter the current date in DDMMYY format. Press
ENTER when entry is complete.
Step 26.
Enter an 8-digit reference designator. Press ENTER
when entry is complete.
2-47
Chapter 2 Operation