Anritsu Site Master - Software Installation

Step 6.
Choose Port Settings, then change to the following
settings if necessary.
Baud Rate: 9600
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
Step 7.
Choose Resource and verify the COM Port Base Ad-
dress and IRQ. Click OK when done.
Step 8.
Click OK again to close the System Properties win-
dow.
Note:
If you changed the COM Port Base Address and/or
IRQ, you will need to restart Windows.
Software Installation
The Site Master Software Tools program is a conventional Microsoft
Windows 3.x program. Installation is similar to all other such pro-
grams. For users new to Windows 3.x, a detailed procedure is given
below.
Step 1.
Insert the ANRITSU Site Master Software Tools For
Windows disk in floppy drive A:\ or B:\.
Step 2. In the Windows Program Manager, pull down the
File menu and select Run. (For Windows 95 users,
select Run under the Start menu.)
Step 3. Type A: (or B:)\SETUP, when the dialog box ap-
pears.
Step 4. Press the Enter key to select the default directory,
C:\SITEMSTR, and begin the Setup routine.
3-5
Chapter 3 Screen Capture Program