Step 3.
For COAX:
Use the Up/Down Arrow key and press ENTER to
select DTF table parameters–D1, D2, CF, CABLE,
PROP VEL, or LOSS. For each parameter selected,
enter the desired numerical value using the keypad or
the Up/Down Arrow key. Press ENTER when data
entry is complete.
For WAVEGUIDE:
Use the Up/Down Arrow key and press ENTER to
select DTF table parameters–D1, D2, CF,
WAVEGUIDE TYPE, CUTOFF, or LOSS. For
each parameter selected, enter the desired numerical
value using the keypad or the Up/Down Arrow key.
Press ENTER when data entry is complete.
NOTE:
The DTF table will not automatically display if the cur-
rent calibration is valid. To display DTF table parame-
ters, press the
DIST
soft key from the Main Menu and
then press the
DTF AID
soft key form the ensuing
soft key menu. Changing CF, Media Type, or D2 will
require a new calibration.
2-42
Chapter 2 Operation
To Next Page
Loading...
