2-56
Chapter 2 Operation
Error Message
Description
DIST REQUIRES
CAL
Distance-to-fault measurements do not pro-
vide usable data with CAL OFF.
NO STORED SWEEP
AT THIS LOCATION
Attempting to recall a display from a loca-
tion that has not been previously written to.
That is, the location does not contain stored
sweep.
USE OPTIONS
MENU TO
SELECT A PRINTER
Attempting to print a display with no printer
selected. Select a printer, then retry.
DISTANCE AND
COAX/WAVEGUIDE
LOSS MODE ARE
INCOMPATIBLE
DTF measurements only display RL or
SWR versus distance.
CANNOT ZERO NO
DETECTOR
INSTALLED
Attempting to perform a Power Monitor
zero adjust function with no RF detector
connected to the Site Master.
CANNOT ZERO
INPUT SIGNAL TOO
HIGH
Attempting to perform a Power Monitor
zero adjust function with an input of greater
than –20 dBm.
POWER MONITOR
OPTION NOT
INSTALLED
Attempting to enter Power Monitor mode
with no option 5 installed.
Table 2-3. Range Error Messages (2 of 2)
To Next Page
Loading...
