Anyview A8 - 16.4 Measurement of C.O.

Patient monitor User’s manual
Chapter 16-2
only the value of C.O., TB (temperature of blood), TI (injectate temperature),
C.I.(cardiac index) and the prompt info can displayed in the parameter zone.
See the interface in the following figure:
16.4 Measurement of C.O.
1
）
Insert the C.O. interface cable to the C.O. module.
2） As shown in the following figure, insert the thermistor connecting
cable of the Swan-Ganz catheter into the thermistor connector, and
connect the In-line Injectate sensor cable to the In-line Injectate Sensor
Housing.
Temperature unit
and TB alarm limit
Prompt information
zone
Blood temperature
Cardiac index
Cardiac output
Injectate
temperature