To Next PageTo Next Page
Need help?Do you have a question about the Anyview A8 and is the answer not in the manual?
Lists and describes the various measurement modules supported by the monitor.
Contains essential safety warnings and precautions for operating the patient monitor.
Provides general safety precautions for installation and operation of the monitor.
Highlights critical safety notes regarding patient number, interference, ingress of liquid, accuracy, and alarms.
Details safe operation conditions, including sterilization, interference, and influences.
Guides on how to set up and configure measurement modules.
Explains how to customize the user interface display style.
Guides on selecting and configuring different main screen layouts.
Classifies alarms into physiological, technical, and prompt messages.
Defines the severity levels for physiological and technical alarms.
Describes how alarms are indicated visually and audibly.
Explains how to adjust the system's alarm volume.
Details how to set alarm limits and status for individual parameters.
Provides guidance on how to respond when an alarm occurs.
Guides on admitting a patient into the monitor system.
Describes how to transfer patient data using the EMS module.
Contains crucial safety information related to ECG monitoring.
Details the step-by-step procedure for ECG monitoring.
Guides on setting ECG parameters like mode, gain, and limits.
Explains the ST segment analysis functionality.
Details the arrhythmia analysis features and settings.
Covers QT/QTc interval monitoring and its related settings.
Provides essential safety information for Resp monitoring.
Details the steps for performing respiration rate monitoring.
Guides on setting respiration rate parameters and alarms.
Contains vital safety information for SpO2 monitoring.
Details the procedure for SpO2 sensor selection and application.
Guides on setting SpO2 parameters, including NIBP on same limb and averaging time.
Lists factors that may influence the accuracy of SpO2 measurements.
Provides safety warnings for temperature probes and measurements.
Details the steps for temperature monitoring, including probe selection and alarm settings.
Contains crucial safety information for NIBP measurements.
Lists limitations and conditions affecting NIBP measurement accuracy.
Details the procedure for NIBP monitoring, including preparation and starting measurements.
Guides on setting NIBP parameters like unit, inflation pressure, and alarm source.
Contains crucial safety information for IBP monitoring.
Details the steps for IBP monitoring, including transducer setup.
Guides on setting IBP parameters like unit, display format, and wave scale.
Details the procedure for zeroing the pressure transducer.
Details monitoring procedures for mainstream, sidestream, and microstream CO2 modules.
Guides on setting CO2 parameters like unit, apnea alarm, and corrections.
Explains the zeroing procedure for CO2 sensors.
Provides essential safety information for CO2 monitoring.
Provides essential safety information for AG monitoring.
Contains crucial safety information for ICG monitoring.
Contains crucial safety information for C.O. monitoring.
Contains crucial safety information for CSM monitoring.
Contains crucial safety information for BIS monitoring.
Covers measurement procedures and settings for ECG, Resp, PR, and SpO2.
Provides detailed technical specifications for ECG, Resp, NIBP, SpO2, Temp, IBP, CO2, AG, ICG, C.O., CSM, and BIS measurements.
Details alarm messages, causes, and levels for System, ECG, Resp, SpO2, Temp, NIBP, IBP, CO2, AG, ICG, C.O., CSM, and BIS.
Lists alarm messages, causes, and levels specific to the EMS module.
General| Brand | Anyview |
|---|---|
| Model | A8 |
| Category | Medical Equipment |
| Language | English |
