Anyview A8 - 9.3 Monitoring Procedure

Patient monitor User’s manual
Chapter 9-4
 The pleth wave is not equal to the intensity of PR signal.
 The production divergence and drive current of LED influence the range
of the peak wavelength of the emitted light by the oxygen probe.
 The monitor does not provide automatic self-examination alarm signal
and the operator has to use SpO2 simulator for self-examination.
9.3 Monitoring Procedure
1. Selecting SpO
2
Sensor
Depending on the patient category, weight and application site, you can
select the SpO
2
sensor as required.
2. Connecting SpO
2
Sensor
Plug the SpO
2
sensor cable into the SpO
2
connector on the measurement
module.
3. Applying SpO
2
Sensor
Clean the application site, such as colored nail polish, and apply the sensor
to the patient.
Warning:
 Do not use the SpO
2
sensor on a limb where the NIBP cuff is applied.
This may result in inaccurate SpO
2
reading due to blocked blood flow
during cuff inflation.
 Do not conduct SpO
2
measurement on the finger smeared with nail
polish, otherwise unreliable measurement results might be produced.
 When using finger sensor, make sure the nail faces to the light
window.
9.4 SpO
2
Display
9.4.1 Waveform Display
Pleth waveform
