Anyview A8 - 17.5 Setting CSM

Patient monitor User’s manual
Chapter 17-3
17.5 Setting CSM
Select CSM parameter area, and enter 【 CSM Param Setup 】 of CSM
parameter setting menu.
 Setting Alarm Level
Select【Alm Setup 】in the CSM parameter setting menu, then select the
【Alm Limit Setup】，you can set the【Alm level】of CSI.
Note: The alarm switch and alarm limit of CSI can only be adjusted
on the CSM module. The detailed information refers to chapter
4.6, 4.7 of ‘Cerebral State Monitor (Model CSM2) User manual’.
 Setting Alarm Print
Select【Alm Print 】in the CSM parameter setting menu, you can select
【On】or【Off】to enable or disable the alarm print.
 Setting SQI Display
Select
【
SQI
】
in the CSM parameter setting menu, you can choose
【
Show
】
or
【
Hide
】
to display the SQI or hide the SQI display.
 Setting Imp Display
Select【Imp】in the CSM parameter setting menu, you can choose【Show】
or【Hide】to display the Imp or hide the Imp display.
 Setting EEG wave Display
If you want to display the EEG wave or hide the EEG wave, set anyone
parameter of the【Trend Display Format】in the【CSM Param Setup】setting
menu, then select
【
EEG wave
】
, you can choose
【
Show
】
or
【
Hide
】
.
 Setting EEG wave Scale
Select【Wave scale】in the【CSM Param Setup】 setting menu, and select
the EEG wave scale in the options as required.
 Setting Trend Display Format
Select
【
Trend Display Format
】
in the
【
CSM Param Setup
】
setting menu,
and select the format in the options as required.
