Anyview A8 - Quick Admitting a Patient; Edit Patient Information

Patient monitor User’s manual
Chapter 6-2
——Remarks: User can enter some more patients’ information, such as
history of genetic disease.
3. Select【OK】, the patient status changes to admitted.
Warning:
 【Patient Type】and【Paced】status will always contain a default value,
regardless of whether the patient is admitted or not. Users must
confirm whether the default value is suitable for the monitored patient.
 For paced patients, you must set【Paced】to【Yes】. If it is incorrectly
set to 【 No 】 , the monitor could mistake pace pulses for regular QRS
complexes and fail to alarm during asystole.
 For non-paced patients, you must set【Paced】to【No】, otherwise, the
system can not detect the arrhythmia related to Ventricular Premature,
and will not conduct ST analysis.
6.2 Quick Admitting a Patient
Use“Quick Admit” only if you do not have the time or information to fully
admit a patient. Complete the rest of the patient information details later.
To quick admit a patient,
1. Select【Patient Manage.】smartkey→【Quick Admit】, and select【Yes】
in the window popped up to discharge the previous patient and admit a new
patient.
2. Set【Patient Type】and【Paced】, and select【OK】, the patient status changes
to admitted.
6.3 Edit Patient Information
After a patient has been admitted, you can edit the patient information in
following ways:
1. Select【Patient Manage.】smartkey→【Pat. Information】.
2. Edit the patient information in the popped up menu.
3. Select【OK】to confirm.
