Anyview A8 - Page 195

Patient monitor User’s manual
Chapter 19-22
Waveform
Upper scale
Lower scale
You can start and stop NIBP measurement by the following two ways:
 Select【Module Setup】→【NIBP Setup】→【STAT】to start NIBP
measurement. Detail operation is select 【 STAT 】 after you finish
connecting the sensor. The module measures NIBP continuously in 5
minutes then press the button on the front panel to stop it.
 Press the button on the front panel directly to start NIBP
measurement and press it once again to stop the measurement.
19.5.7 IBP
Note: More details about IBP measurement principle, safety
information and monitoring steps turn to Chapter 12: Section
12.1, 12.2 and 12.3.
1. IBP Displaying
 Waveform Displaying:
 Parameter Displaying:
2. Setting IBP
Enter the main menu, Select
【
Module Setup
】
→
【
P1 Setup
】
or
【
P2
Setup 】， a IBP setup window appears. In the window you can set IBP
measurement.
a. Setting Alarm Source
Select 【 ALM Source 】 , choose an appropriate alarm source by
upturning or downturning according to the patient’s actual situation.
b. Setting Unit
Select【Unit】, upturn or downturn to choose an appropriate unit. You

Unit
Sys
Dia
Mean