Patient monitor User’s manual
Chapter 26-4
product be conducted only when necessary according to the regulation of your
Do not clean and reuse disposable electrode.
The recommended disinfector include: isopropyl alcohol 70%, 10%
decolourant solution can be used for sterilization at lower standard. Don’t use
undiluted decolourant (5%
～
5.25% sodium hypochlorite) or other
non-recommended disinfector in order to avoid damage to sensor.
The method of cleaning and sterilization can refer to the corresponding
Do not immerse the sensor in water, solvents, or cleaning solutions (the
sensors and connectors are not waterproof).
Do not sterilize by irradiation, steam, or ethylene oxide.
Do not directly submerge sensor in any liquid.
To avoid long-time harm to sensor, it is suggested that sterilization to the
product is conducted only when necessary according to the regulation of
The recommended disinfector: 70% isopropyl alcohol solution, glutaric
dialdehyde solution and 10% decolourant solution.
The method of cleaning and sterilization can refer to the corresponding
Do not repeatedly sterilize and use disposal temperature sensor.
To avoid long-time harm to sensor, it is suggested that sterilization to the
product be conducted only when necessary according to the regulation of
Temp sensor can only withstand 80～100℃ temperature for a short time
and the heating temperature is not allowed to surpass 100℃.
a) Please regularly clean the product;
b) Remove cuff from connector and pull out airbag from sheath;
c) Submerge clean and soft medical gauze pad or other soft cleaning tools into
To Next Page
Loading...
