Patient monitor User’s manual
Chapter 1-16
—— After plugging in EMS/MPS, please make sure whether the indicating
lamp on EMS/MPS lights up. If not, please pull out and plug in
Plug in and pull out of other modules
—— Plug in module: make a module point to the position of the slot and push
it into the slot until the buckle at bottom of the module clicks into place.
—— Pull out module: lift up the buckle at bottom of the module, and pull out
the module and remove it.
—— After plugging in a module, please make sure whether the indicating
lamp on the module lights up. If not, please pull out and plug in the
1.3.2 EMS/MPS Introduction
EMS/MPS can simultaneously monitor 3-lead, 5-lead or 12-lead ECG
(including ST monitoring),Resp, SpO
2
, pulse rate, 2-channel Temp, NIBP and
EMS has a color display screen and built-in lithium battery while MPS
doesn’t (shown as follows).When an EMS disconnects with the host monitor,
the EMS can be used as a stand-alone monitor with battery power to keep on
monitoring a patient. When connecting with a new host monitor, the EMS can
upload the patient information, trend data and measuring settings of the
monitored patient to the host monitor, to ensure no break in monitoring.
Therefore, it is especially suitable for a patient during transportation.
The detailed information about EMS used as a stand-alone monitor refers
While connecting with a host monitor, the EMS can get power from the
host monitor and the battery can be charged through the host monitor.
To Next Page
Loading...
